DHCP Setup

Configuring TCP/IP For Windows

DHCP SETUP


	1. Click "START - SETTINGS -CONTROL PANEL


	2) Double Click "Network" control panel


	3) Highlight the TCP/IP protocol in the Network Components box (Single CLICK on it). You will want the protocol that is bound to the Ethernet card.( ex. TCP/IP Intel pro/10+) if there are multiple instances of TCP/IP here.


	In this example we would single click on TCP/IP Then Click PROPERTIES

		Some people have asked me if this is all that is in my Network Box. The answer is YES.


	4) Click on the "Properties button. Verify that " Obtain an IP address automatically is selected




	5) Click on the " DNS Configuration" tab. Verify that " Disable DNS" is selected.


	6) Click on the " WINS Configuration"tab. Verify that"Disabled WINS Resolution" is selected


	7) Click the OK BUTTON. 8) Click on the Identification tab. Check the " Computer name" field, Make sure your computer is correct. If you don't have your computer name call tech support an ask them for it. Work group should be @HOME.


	DHCP is Now Setup




		We at Zaxie hope that the information in this website is valuable to you. Your use of the information contained in this website, however, is at your sole risk. All information in this website is provided "as is", without any warranty, whether express or implied, of its accuracy, completeness, fitness for a particular purpose, title or non-infringement, and none of the third-party products or information mentioned in the work are authored, recommended, supported or guaranteed by Zaxie and the @Home Network. Zaxie and the @Home Network shall not be liable for any damages you may sustain by using this information, whether direct, indirect, special, incidental or consequential, even if it has been advised of the possibility of such damages.